If you wish to contribute or participate in the discussions about articles you are invited to contact the Editor

Ionospheric Models for Single Frequency Receivers: Difference between revisions

From Navipedia
Jump to navigation Jump to search
No edit summary
mNo edit summary
 
(4 intermediate revisions by 2 users not shown)
Line 1: Line 1:
{{Article Infobox2
{{Article Infobox2
|Category=Fundamentals
|Category=Fundamentals
|Authors=J. Sanz Subirana, JM. Juan Zornoza and M. Hernandez-Pajares, University of Catalunia, Spain.
|Authors=J. Sanz Subirana, J.M. Juan Zornoza and M. Hernández-Pajares, Technical University of Catalonia, Spain.
|Level=Basic
|Level=Basic
|YearOfPublication=2011
|YearOfPublication=2011
|Logo=gAGE
|Title={{PAGENAME}}
|Title={{PAGENAME}}
}}
}}
Single frequency receivers needs to apply a model to remove the [[Ionospheric Delay|ionospheric refraction]], which can reach up to few tens of meters, depending on the elevation of rays and the ionospheric conditions.
Single frequency receivers need to apply a model to remove the [[Ionospheric Delay|ionospheric refraction]], which can reach up to few tens of meters, depending on the elevation of rays and the ionospheric conditions.


The models used in [[GPS]] and [[GALILEO|Galileo]] are described in [[Klobuchar Ionospheric Model]] and [[NeQuick Ionospheric Model]]. The GPS/Galileo satellites broadcast the parameters needed to run these ionospheric models.  
The models used in [[GPS]] and [[Galileo General Introduction|Galileo]] are described in [[Klobuchar Ionospheric Model]] and [[NeQuick Ionospheric Model]]. The GPS/Galileo satellites broadcast the parameters needed to run these ionospheric models.  


In [[GLONASS General Introduction|GLONASS]], there is no ionospheric model applied and thus, there is no broadcast of any parameter. However, anyone of the [[GPS]] or [[GALILEO]] ionospheric models could be used for [[GLONASS Signal Plan|GLONASS signals]], by applying a correction factor given by their relative squared frequencies ratio.
In [[GLONASS General Introduction|GLONASS]], there is no ionospheric model applied and thus, there is no broadcast of any parameter. However, any of the [[GPS]] or [[Galileo General Introduction|GALILEO]] ionospheric models could be used for [[GLONASS Signal Plan|GLONASS signals]], by applying a correction factor given by their relative squared frequencies ratio.


[[Category:Fundamentals]]
[[Category:Fundamentals]]
[[Category:GNSS Measurements Modelling]]
[[Category:GNSS Measurements Modelling]]

Latest revision as of 18:35, 8 July 2018


FundamentalsFundamentals
Title Ionospheric Models for Single Frequency Receivers
Author(s) J. Sanz Subirana, J.M. Juan Zornoza and M. Hernández-Pajares, Technical University of Catalonia, Spain.
Level Basic
Year of Publication 2011

Single frequency receivers need to apply a model to remove the ionospheric refraction, which can reach up to few tens of meters, depending on the elevation of rays and the ionospheric conditions.

The models used in GPS and Galileo are described in Klobuchar Ionospheric Model and NeQuick Ionospheric Model. The GPS/Galileo satellites broadcast the parameters needed to run these ionospheric models.

In GLONASS, there is no ionospheric model applied and thus, there is no broadcast of any parameter. However, any of the GPS or GALILEO ionospheric models could be used for GLONASS signals, by applying a correction factor given by their relative squared frequencies ratio.