If you wish to contribute or participate in the discussions about articles you are invited to contact the Editor
Ionospheric Models for Single Frequency Receivers: Difference between revisions
Rui.Pereira (talk | contribs) No edit summary |
mNo edit summary |
||
| (4 intermediate revisions by 2 users not shown) | |||
| Line 1: | Line 1: | ||
{{Article Infobox2 | {{Article Infobox2 | ||
|Category=Fundamentals | |Category=Fundamentals | ||
|Authors=J. Sanz Subirana, | |Authors=J. Sanz Subirana, J.M. Juan Zornoza and M. Hernández-Pajares, Technical University of Catalonia, Spain. | ||
|Level=Basic | |Level=Basic | ||
|YearOfPublication=2011 | |YearOfPublication=2011 | ||
|Title={{PAGENAME}} | |Title={{PAGENAME}} | ||
}} | }} | ||
Single frequency receivers | Single frequency receivers need to apply a model to remove the [[Ionospheric Delay|ionospheric refraction]], which can reach up to few tens of meters, depending on the elevation of rays and the ionospheric conditions. | ||
The models used in [[GPS]] and [[ | The models used in [[GPS]] and [[Galileo General Introduction|Galileo]] are described in [[Klobuchar Ionospheric Model]] and [[NeQuick Ionospheric Model]]. The GPS/Galileo satellites broadcast the parameters needed to run these ionospheric models. | ||
In [[GLONASS General Introduction|GLONASS]], there is no ionospheric model applied and thus, there is no broadcast of any parameter. However, | In [[GLONASS General Introduction|GLONASS]], there is no ionospheric model applied and thus, there is no broadcast of any parameter. However, any of the [[GPS]] or [[Galileo General Introduction|GALILEO]] ionospheric models could be used for [[GLONASS Signal Plan|GLONASS signals]], by applying a correction factor given by their relative squared frequencies ratio. | ||
[[Category:Fundamentals]] | [[Category:Fundamentals]] | ||
[[Category:GNSS Measurements Modelling]] | [[Category:GNSS Measurements Modelling]] | ||
Latest revision as of 18:35, 8 July 2018
| Fundamentals | |
|---|---|
| Title | Ionospheric Models for Single Frequency Receivers |
| Author(s) | J. Sanz Subirana, J.M. Juan Zornoza and M. Hernández-Pajares, Technical University of Catalonia, Spain. |
| Level | Basic |
| Year of Publication | 2011 |
Single frequency receivers need to apply a model to remove the ionospheric refraction, which can reach up to few tens of meters, depending on the elevation of rays and the ionospheric conditions.
The models used in GPS and Galileo are described in Klobuchar Ionospheric Model and NeQuick Ionospheric Model. The GPS/Galileo satellites broadcast the parameters needed to run these ionospheric models.
In GLONASS, there is no ionospheric model applied and thus, there is no broadcast of any parameter. However, any of the GPS or GALILEO ionospheric models could be used for GLONASS signals, by applying a correction factor given by their relative squared frequencies ratio.